| pointA | One corner of the rectangle. |
| pointB | Diagonally opposite the point A corner of the rectangle. |
| layerMask | @param layerMask Фильтр для обнаружения коллайдеров только на определённых слоях. |
| minDepth | @param minDepth Включает только объекты с координатой Z (глубиной) выше, чем это значение. |
| maxDepth | @param maxDepth Включает только объекты с координатой Z (глубиной) меньше, чем это значение. |
Collider2D The collider overlapping the area.
Checks if a collider falls within a rectangular area.
The rectangle is defined by two diagonally opposite corner coordinates in world space. You can think of these as top-left and bottom-right but the test will still work if the ordering of the points is reversed. The optional layerMask allows the test to check only for objects on specific layers.
Although the Z axis is not relevant for rendering or collisions in 2D, you can use the minDepth and maxDepth parameters to filter objects based on their Z coordinate. If more than one collider falls within the area then the one returned will be the one with the lowest Z coordinate value. Null is returned if there are no colliders in the area.
See Also: OverlapAreaAll & OverlapAreaNonAlloc.
| pointA | One corner of the rectangle. |
| pointB | Diagonally opposite the point A corner of the rectangle. |
| results | The array to receive results. The size of the array determines the maximum number of results that can be returned. |
| contactFilter | The contact filter used to filter the results differently, such as by layer mask, Z depth. Note that normal angle is not used for overlap testing. |
int
Returns the number of results placed in the results array.
Checks if a collider falls within a rectangular area.
The rectangle is defined by two diagonally opposite corner coordinates in world space. You can think of these as top-left and bottom-right but the test will still work if the ordering of the points is reversed.
This function returns the number of colliders found and places those colliders in the results array. The results can also be filtered by the contactFilter. Note that filtering by normal angle is not available for overlap functions.