Size by Speed module
Здесь можно изменить размер частиц соответственно их скорости в единице расстояния в секунду.
Свойства
| Property | Function |
|---|---|
| Separate Axes | Control the particle size independently on each axis. |
| Size | Кривая, определяющая размер частицы по отношению к диапазону своей скорости. |
| Speed Range | Нижняя и верхняя граница диапазона скорости, на которую накладывается кривая размера (скорости вне этого диапазона будут наложены на конечные вершины этого градиента). |
Детали
Some situations will require particles which vary in size depending on their speed. For example, you would expect small pieces of debris to be accelerated more by an explosion than larger pieces. You can achieve effects like this using Size By Speed with a simple ramp curve that proportionally increases the speed as the size of the particle decreases. Note that this should not be used with the Limit Velocity Over Lifetime module, unless you want particles to change their size as they slow down.
Speed Range specifies the range of values that the X (width), Y (height) and Z (depth) shapes apply to. The Speed Range is only applied when the size is in one of the curve modes. Fast particles will scale using the values at the right end of the curve, while slower particles will use values from the left side of the curve. For example, if you specify a Speed Range between 10 and 100:
- Speeds below 10 will set the Particle size corresponding with the left-most edge of the curve.
- Speeds above 100 will set the Particle size corresponding with the right-most edge of the curve.
- Speeds between 10 and 100 will set the Particle size determined by the point along the curve corresponding to the Speed. In this example, a Speed of 55 would set the size according to the midpoint of the curve.
Non-uniform particle scaling
You can specify how a particle’s width, height and depth size changes by speed independently. In the Size by Speed module, check the Separate Axes checkbox, then choose how the X (width), Y (height) and Z (depth) of the particle is affected by the speed of the particle. Remember that Z will only be used for Mesh particles.