WheelCollider.suspensionSpring

Switch to Manual
public JointSpring suspensionSpring;

Description

The parameters of wheel's suspension. The suspension attempts to reach a target position by applying a linear force and a damping force.

The value suspensionSpring.spring describes the stiffness of the spring. It is expressed in Newtons per metre. The spring strength has a profound influence on handling by modulating the time it takes for the vehicle to respond to bumps in the road and on the amount of load experienced by the tire. Larger values make the suspension reach the target position faster but at the cost of increased load and handling variability. Smaller values provide a smoother but less responsive ride.

The value suspensionSpring.damper describes the rate at which the spring dissipates the energy stored in the spring. It is expressed in Newtons seconds per metre (equivalent to Newtons per unit speed). Larger values make the suspension reach the target position slower, while lower values make the car appear more bouncy. Vehicle suspensions typically have a response close to critical damping.

The rest coordinate of the wheel is specified by suspensionSpring.targetPosition. This value describes the rest coordinate of the wheel as a fraction in range (0, 1) along the suspensionDistance. Zero value maps to full extension along the suspension travel, while a value of one maps to fully compressed suspension. Default value is 0.5, which sets the rest coordinate of the wheel to the mid-point between the suspension at maximum elongation and maximum compression. Typical values would be in range (0.3, 0.7).


Did you find this page useful? Please give it a rating: